Model: AZW-ZGM130S-02

Z-Wave Modules

Item specifics

Main parameter	Description	Note
Protocol	Z-Wave
Frequency	865.2MHz-926.3MHz
Transmission Rate	9.6Kbps, 40Kbps, 100Kbps
Crystal oscillator	39MHz	-
Modulation	FSK, GFSK
FLASH	512KB	-
Operation Voltage	1.8-3.8V	-
Operation Temperature	-40℃～85℃
Interface	Include: PWM, I2C, ADC, UART
Size	16242mm	-
Maximum transmitted power	13dBM
Deep sleep mode operating current	5.5uA
Receive Sensitivity	-97.9dBm
RX operating current	9.8mA(Test Program)
TX operating current	13.3mA(Test Program)

Item	Pin No.	type	Features
1	NRST	Reset	Can be put it in no connection
4	GPIO0	IO	Can be used as an interrupt wake up in sleeping mode
5	SWO	IO	Can be used as an interrupt wake up in sleeping mode
6	PWM3	IO	Can be used as an interrupt wake up in sleeping mode
8	VCC	3.3V	power
9	GND	Grounded	Grounded
13	PWM2	IO	Can be used as an interrupt wake up in sleeping mode
14	GPIO3	IO	Can be used as an interrupt wake up in sleeping mode
15	RXD	IO	1, When doing other serial products, this port can be used as z-wave RXD to connect with external MCU TX . 2, Can be used as an interrupt wake up in sleeping mode
16	TXD	IO	When doing other serial products, this port can be used as z-wave RXD to connect with external MCU TX .
17	VCC	3.3V	Factory test ports
18	CLK	Burning Point
19	TMS	Burning Point
20	RST	Reset	Can be put it in no connection
21	TX0	Factory Testing Point TX	Factory test ports
22	RX0	Factory Testing Point RX	Factory test ports
23	GND	Grounded	Factory test ports
	IPEX4	IPEX4	Connect with external antenna